Skip to content
Topvico 433MHZ Wireless Panic Button & Caregiver Pager - Online Manual

Topvico 433MHZ Wireless Panic Button & Caregiver Pager - Online Manual

At a Glance

topvico wireless SOS panic button receiver caregiver pager 01

Q: How to pair with 433Mhz hub / receiver and SOS button / sensors?

A: - Plug the receiver into the socket.
- Press Music Up Button or Music Down Button to choose your favorite ringtone (After paired, if you want to change the chime tone, you need to pair the SOS button / sensors again . Please refer to Pairing.).

- Press and hold the pairing button until you hear one beep and indicator light blue, then the receiver goes into the pairing mode.

- Press the SOS button / trigger sensors, then the receiver beep and flash once to indicate the pairing is complete. The receiver will beep and flash twice to indicate that the pairing fails if the transmitters are full (max to 100).

Volume Adjustment

Short press the Volume Button to adjust the volume level of ringtone from highest to mute, then skip to highest.

topvico wireless caregiver pager panic button 02

Reset / Deleting Transmitters

This process resets the receiver to factory settings and removes all pairings.
Press and hold Reset Button until you hear four beeps with light ring flashing four times.

topvico wireless caregiver pager sos panic button 03

Installation

Before installation, please test the push button range first.
It is not advised to mount the transmitter onto metal surfaces as the material can block RF signals between the transmitter and the receiver.

Q: Need more accessories to the system?

A: Please check the page of accessories.

Or order in our Aliexpress store accessories.

Topvico 433MHZ panic button caregiver pagerTopvico sos bracelet watchTopvico water leak detector alarm

Leave a comment

Your email address will not be published..

Cart 0

Your cart is currently empty.

Start Shopping